The actual effect principle of the quick joint of the water pipe is to use the extra moment of inertia to realize the damage of the pipe or the connection of two pipes together. The extra force of the quick connector is mostly based on the inch thread, that is to say, everyone is based on tightening the screws on the quick connector, thus promoting the inner diameter of the quick connector to become smaller, and finally the hydraulic transition connector is based on the extrusion. Types connect pipes together.

There are two broad categories of quick connectors for water pipes: the first is that the inch thread is a long barrel-shaped quick connector. The connection type connector manufacturer is connected according to the way of socket and socket. In the case of assembly, the two water pipes are inserted into the quick connector, and then the screws on both sides of the quick connector are tightened with the matching common tools. The squeezing force squeezes the hose.

The second type of quick connector is a three-in-one quick connector. This type of quick connector is composed of 2 parts, which are connected and installed using anchor bolts. In the case of the US-made threaded ORFS installation, you open the anchor bolt to open a part of the connector, and then put the water pipe inside. After the development, install the anchor bolts, and use the tightening system to tighten the anchor bolts, so as to achieve the repair and connection of pipeline damage.

What are the advantages and disadvantages of water pipe quick connectors?

The advantages of the connection of water pipe quick joints are actually very obvious, that is, the convenience and speed of construction, especially in the construction. The quick connector of the hydraulic pipe joint manufacturer only needs to use the matching simple and common tools to carry out immediately, and the demand for the part to which the pipe connection belongs is very low. The other thing is its low cost.